Halloween is only the start of Candy Season. It typically lasts until the New Year, when healthy eating resolutions kick in.
If
you are making your own candy this fall, perhaps you are confused by the stages sugar goes through as it cooks. Thread Stage? Soft-Ball Stage? Hard-Ball?
Soft-Crack? Hard-Crack? Caramelization? Each of these is achieved at a small
temperature range as the sugar is heated.
The
correct stage determines the texture of candy. Fudge only goes to the soft-ball
stage. Taffy stops cooking at the hard-ball stage. Nougat goes to soft-crack
and the coating for candy apples may go to hard-crack.
It’s
difficult to tell what stage your sugar syrup is at during candy making… unless
you use a candy thermometer. This handy tool is specifically designed to
measure the temperature of boiling sugar syrup up to 400 F (200 C).
When
you get a new candy thermometer, or retrieve one you have not used in a while,
it is wise to test it first. Immerse the bulb in boiling water. It should read
212 F (100C) or whatever the temperature of boiling water is at your altitude. The candy thermometer should read the correct temperature. If it
doesn’t, get a new one.
It
is also important to read the candy thermometer correctly!
Attach
the thermometer to the side of the pan after the sugar syrup has come to a
boil. Be sure the heat sensor is appropriately placed in the syrup, following
the manufacturer’s directions. Usually this means the bottom of the thermometer
must be completely submerged, but NOT touching the bottom of the pan. If the
liquid is too shallow for complete immersion, you can carefully tip the pan
until the thermometer is deep enough in liquid to read accurately.
To clean a candy thermometer, let it cool first so the glass doesn’t crack. Then to remove hardened sugar or caramel from the bulb by putting the thermometer into a pan of water and gradually heating it to boiling. The heat will remove the sugar. Then you can hand wash in warm soapy water with a soft sponge. Be sure not to get the electrical parts of the thermometer wet if your thermometer brand has a digital display or any electronics in the handle.

No comments:
Post a Comment
Got a Comment?